Elastomeric Sika Concrete Protection for Abbotsford
When water threatens a foundation or concrete needs structural repair, Sika delivers the chemistry that moves with the slab instead of cracking away from it. Abbotsford Concrete applies Sika waterproofing, injection systems, repair mortars and floor coatings in the full manufacturer sequence, with primer, body and topcoat installed to spec. Every project includes a free written estimate.
Why Sika Elastomeric Systems Outperform Rigid Coatings
Concrete moves. Seasonal freeze-thaw cycles, ground settlement, and structural loads all cause the slab to shift slightly. A rigid waterproofing coating cannot move with it, so it cracks, and water finds the gap. Sika waterproofing membranes (Sikalastic, Sikagard) are elastomeric, meaning they flex with the substrate and stay sealed.
When a crack is already active and leaking, Sika crack injection (SikaFix HH, SikaFlex) fills it from the inside out, stopping the water and stabilizing the concrete at the same time. No excavation needed in most cases.
We evaluate whether the issue is preventive waterproofing, an active leak, structural damage, or a finished floor, then select the matching Sika product line and chemistry for the substrate.
Prepare the surface
The concrete is cleaned, profiled and tested for moisture content to meet the Sika system requirements. Cracks are routed and cleaned if injection is the solution.
Apply primer, body, topcoat
We install the full Sika sequence in the published order, at the correct temperature, lift thickness and cure time, using the exact chemistry the specification calls for.
Document and warranty
The install is recorded with photos and data sheets, the manufacturer warranty is registered, and you receive all documentation for future maintenance or repairs.
Sika in the field
Where Sika Repair Mortars and Waterproofing Earn Their Keep
Most Sika work happens below grade, where water pressure and freeze-thaw cycles test every seal. Sika waterproofing systems on foundation walls and under slabs are where the elastomeric advantage shows, flexing with concrete movement instead of cracking off.
Inside the building, Sika crack injection stops active leaks through walls and slabs without digging up the yard, and Sika MonoTop mortars rebuild structural concrete to the original profile. That combination is why a Sika install holds through multiple seasons instead of becoming a repeat project. Our epoxy garage floor and commercial epoxy floor work also uses Sika topcoat systems.
Which Sika line for which job, injection, waterproofing and warranty in Abbotsford.
Often, yes. Sika crack injection with SikaFix HH polyurethane seals active cracks from inside the wall and stops the leak, without needing to excavate the outside of the foundation in most cases.
Sika waterproofing is a system applied to a whole wall or slab to keep water out. Crack injection is a targeted repair that seals a specific crack already letting water through.
Yes, the right one can. Sika MonoTop repair mortars rebuild spalled and structural concrete to original profile and strength, with the chemistry chosen to suit whether the repair is cosmetic or load-bearing.
Because elastomeric chemistry actually flexes with concrete movement. A rigid coating cracks where the substrate moves, and the leak comes back. Sika systems were developed to flex and seal, which is why they hold up below grade.
Yes. We install Sika products as a system, primer, body and topcoat in the published sequence and chemistry. That is what keeps the manufacturer warranty intact and what makes the install actually perform.
Sika crack injection stopped a leak we had chased with caulking for years. They sealed it from inside and the basement has been dry through two springs.
M. E.
Homeowner
★★★★★
Full Sika waterproofing on a new foundation. Elastomeric so it can flex with the concrete and not crack off the way the old rigid coating did.
A. D.
Builder
★★★★★
SikaTop repair on a worn loading-dock area. Profile is exact, took our forklift traffic, and they handed over the data sheets for our records.
J. E.
Commercial property manager
★★★★★
They install Sika as a full system, not just a coat of the product they have on the truck. That difference shows up in how long the install holds.
L. G.
General contractor
From the blog
Concrete Guides & Articles
Practical reading on planning, finishes and caring for concrete in Abbotsford.
A leaking foundation, an active crack, structural damage or a finished floor, tell us what is happening and we will spec the right Sika system and send a written, itemised quote.
Cost & Planning